Knee Dot Engine
/
Knee Dot Engine
/
Manual user interaction in routine examinations limits efficiency and increases inter-user variation in results. The Knee Dot Engine provides efficient and flexible 2D and 3D imaging workflows, enabling consistent slice coverage and positioning with AutoAlign and AutoCoverage.
- Automatic positioning and sizing of slices and the Field of View
- Reduction of metal artifacts with WARP1
- Motion-insensitive scanning with BLADE
- The Large Joint Dot Engine expands on the Knee
Dot Engine
General Requirements
System
- MAGNETOM Prisma
- MAGNETOM Sola
- MAGNETOM Vida
- MAGNETOM Altea
- MAGNETOM Skyra
- Biograph mMR
- MAGNETOM Aera
- MAGNETOM Lumina
Minimum Software Version
syngo MR D11
Other
Please Note: Additional technical pre-requisites may apply. Upon receiving your request, your local Siemens representative will clarify whether your system meets the requirements.
Did this information help you?
1
The MRI restrictions (if any) of the metal implant must be considered prior to patient undergoing MRI exam. MR imaging of patients with metallic implants brings specific risks. However, certain implants are approved by the governing regulatory bodies to be MR conditionally safe. For such implants, the previously mentioned warning may not be applicable. Please contact the implant manufacturer for the specific conditional information. The conditions for MR safety are the responsibility of the implant manufacturer, not of Siemens.
